For all EU customers, please read through our EU shipping page for VAT information

0

Ihr Warenkorb ist leer

Neu

RSMK3ECU

Focus RS Mk3 ECU Housing

As the standard ECU housing in the n/s/f wheel arch is only large enough for the standard ECU, it is impossible to house upgraded components effectively. When upgrading to Syvecs management, the standard plastic housing will not accommodate the hardware and the result is an ill-fitting assembly which will also be open to the elements.

Water and dirt ingress is highly undesirable, as it will very quickly cause corrosion and most likely lead to poor electrical contact. As these are very expensive components, we chose to create this all-alloy upgrade which not only protects the equipment properly but also has a much-increased capacity.

This allows further Syvecs modules to be added as required and fits neatly into the original location. No additional drilling or cutting is required to install the new housing, it is a simple installation and provides a total “fit & forget” solution.

Customer Reviews
5.0 Based on 1 Reviews
5 ★
100% 
1
4 ★
0% 
0
3 ★
0% 
0
2 ★
0% 
0
1 ★
0% 
0
Write a Review

Thank you for submitting a review!

Your input is very much appreciated. Share it with your friends so they can enjoy it too!

Filter Reviews:
    A
    08/16/2024
    Anonymous
    United Kingdom United Kingdom
    I recommend this product

    focus rs ecu housing

    Compared to the factory ecu housing this is far better the Ford item has holes in the top and side letting water in from around the headlight , and a drain slot that is higher than the lowest point .The pro alloy housing sits upright there are very few holes in it and is virtually impossible for water to enter. Construction is very good fitting is easy the only fiddly part is getting the wiring loom grommet to sit in the housing but a little patients and it done .